The R&S SMATE200A is based on the successful R&S SMU200A but is specifically designed to meet production requirements. It comes without a display or keys on the front panel, and its connectors are located at the rear. In addition, it is optimized for faster setting times in order to reduce test time.
- Very short setting times for frequency and level (<3 ms) In List mode, setting time reduced down to <400 µs through use of predefined frequency and level values
- Flexibly addressable Fast Hop mode with setting times same as in List mode
- Multisegment waveform function enables fast switching between different test signals in baseband
- Electronic attenuator for entire frequency and level range
- Status LEDs on front, connectors on rear
- Very low SSB phase noise of typ. 135 dBc, or typ. 140 dBc with the Low Phase Noise option (20 kHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)
- Wideband noise of typ. 153 dBc (>5 MHz carrier offset, f = 1 GHz, 1 Hz measurement bandwidth)
- High output power of typ. +26 dBm with High-Power Output option
- Very high level repeatability of typ. 0.05 dB
- I/Q modulator with 200 MHz system bandwidth
- Excellent ACLR performance of typ. +70 dB with 3GPP FDD
- Up to two complete independent signal generators in one unit
- Choice of 3 GHz and 6 GHz frequency options in both paths
- Up to two independent baseband sources that not only support realtime signal generation but also offer arbitrary waveform generation with up to 64 Msamples each
- Digital Standard Eutra/LTE available
- Remote-controllable via LAN (Gigabit Ethernet) and GPIB
Specifications
Frequency Range Min.
100.0 kHz
Frequency Range Max.
6.00 GHz
Modulation
AM, FM, Pulse, Phase, FSK, Vector, Wideband AM, ASK
